Using Tap Control

When you need to focus on interpersonal communication coming from a specific direction, you can automatically set noise cancellation to low in one earcup.

Notes: 

• By default, the tap control operation switch is set to off.
• Tap control is available only when the acoustic noise cancelling (ANC) switch is in the high or med position
• Tap control is disabled during extreme levels of ambient noise to ensure proper noise reduction performance and intercom communication quality. However, you can still set the noise cancellation level to low in both earcups using the acoustic noise cancelling (ANC) switch

 Using Tap Control

1. Make sure the acoustic noise cancelling (ANC) switch is in the high or medium position.
   
2. Inside the control module battery compartment, set the tap control switch to ON.
3. Firmly double-tap the outside of the earcup.
   

 

Switching earcups

• To switch Tap Control to the other earcup, firmly double tap the other earcup

Reset Tap Control

• To resume noise cancellation in both earcups, double-tap the earcup where Tap Control is currently active, or move the acoustic noise cancelling (ANC) switch to another position